CKE 20 Pairs Invisible Cable Railing Kit, T316 Stainless Steel 1/8" Invisible Receiver and Swage Stud End for 2"x2", 4"x4" Wood/Metal Post, Invisible Deck Stair Cable Railing Hardware Tensioner CR31

Everything is great but trying to get the right tension is not the easiest.

Used these on an aluminum post railing for our deck. They were easy to install with a swaging tool. They look good and allowed for good tension of the cable. The only thingI wish were different is that the terminal ends that are not threaded did not have a hex key hole on the face for tightening as that end is not meant to tighten/tension the cable. It would give it a sleeker look. But aside from that they look good and work very well.

Great product! Using for the stringers on my deck. Cabling looks nice so I can keep my view unobstructed by the normal wood pieces on the vertical handrails. Using these with cable horizontally. Turned out great and the second time I’ve purchased these. Real nice finish and high quality.

Easy to use. Works well and looks great!

Unfortunately if you are using this over a short span the cable twists when tightening. Due to the design there is no way to hold the piece connected to the cable in place while tightening from the end with a hex wrench. I would look for a different product so you get a better look. There is also only a 30 day return window, and since I did not start my project immediately, there is no way to return this item. Thus, had to spend more money to buy a different turnbuckle kit. Bottom line is I would buy a different product.

Worked perfectly

This product is terrible. You cannot tighten the turnbuckle to tighten the wire. The wire just turns causing the wire to wind up. If you try hold the wire from turning it just ruins the wire. Waste of time and money.I noticed another manufacturer had a similar design and just made a product improvement with a tool that holds the swage in place so you can tighten. Unfortunately I already purchased this product.

This product had everything as indicated and nothing was damaged. I would have liked the threads to be through the length of the female connector end which would give a longer adjustment, but I do like the clean ,nice looking end that it creates. I will buy them again. Thanks.