10361(5-pack) Universal Straight Stainless Steel Pipe Burner for Costco Kirkland, Charmglow, Nexgrill, Perfect Glo, and Other Grills by BBQ Mart

They are not like original ne grill units. The original had square pressing limiting the gas flow. These just have holes drilled in so too much gas flow out which makes the high strung unusable and difficult to ignite.

They fit and work however NOT AS ADVERTISED the burner tubes are not straight and the person that wrote the had line must have never seen this item cause it is not stainless it is made of varry inexpensivemetal that is attached to magnet and as we all probably know stables steel is not . I had to work on the tubes to make them fit and that probably voided all warranties, but that's ok for me, it may not work for you if you are not handy. I know it's hard to admit for some people but it's the truth. The tubes are longer if you have to make them straight so keep that in mind before you orther them. Good luck and stay safe.

Longer than advertised, however that did not matter in my case! In my case the screws that hold them in place were rusted solid. SO I just cut the old ones out and left a edge for the new ones to rest on. The news ones were 1/4" too long, so I cut them as well and then laid them on top of the old ones. A dap of jbweld and they don't move.

Parts were very inexpensive and were very easy to install (loosen the 2 screws at the back of the grill, slide out the defective tube; slide he new tube into the knob area, then tighten the 2 screws at the back of the grill. Note: Prior to tightening the screws, I decided to test turn on the grill to make sure the flame was burning properly. The tubes have adjustable air vents to control the air/propane mixture.

Just undid a hold down screw and slipped these in. Replaced the screw and good to grill.

These fit well and worked as expected

LOVE LOVE LOVE. I have to replace the burners about 1x a year. Currently I am on a odd schedule where only some need replaced, HOWEVER buying the five pack means I have a couple extra in the garage for when one goes bad. So happy that these things have become so affordable.

Just like originals.... I wish they were thicker... but then I guess they would last too long (the originals made it 5 years). Note... The old ones are bugers to get off (screw rusted in place)... I ground off the heads then they were loose enough to turn with visegrips (Buy stainless screws to replace)...