🚴♂️ Rev Up Your Adventure with the YFM350 Carburetor!
The YFM350 Carburetor is a high-performance replacement part designed for various Yamaha ATV models from 1987 to 2004. It features a 36mm intake diameter and a 46mm air filter diameter, ensuring optimal air-fuel mixture for improved engine performance. Made from durable aluminum, this carburetor comes with an intake manifold and screw package, making it a complete solution for enhancing your ATV's power and torque.
| Exterior Finish | Aluminum |
| Compatible with Vehicle Type | All Terrain Vehicle |
| Specific Uses For Product | Performance,Power |
| Recommended Uses For Product | All Terrain Vehicle |
J**G
carb
carb works great.
B**N
Fit right on
Ordered this for my Yamaha Warrior 350.Arrived quickly. Installed perfectly and except for idle speed adjustment, it ran perfectly.Install and go !!
C**Y
Drain Leaks (everything leaks)
Bowl drain leaks - tried to tighten it and it is already so tight the screw nearly stripped. The jets also aren't labeled so no idea what anything is. They sent another set of (I assume) a different size but they aren't labeled either and there's no manual to tell you.Got my 1993 BigBear started though and seemed to idle ok, Hopefully the jets from the original Mikuni fit in this so i can swap if needed.- Update at about 1 month installed:This thing leaks. Everywhere. From the bowl drain and from the accelerator bar. I assume its leaking into the bowl and overflowing too as it is extremely hard to start and runs terrible for the first minute and then it runs ok but not great after that. If I turn it off for 10 seconds I can't start it again. I'm using E10 gas as it's pretty much impossible here to find ethanol free without pay 40% more.
M**N
right fit
Will buy thing like this again
B**0
Runs good
No issues runs good.
M**R
Perfect fit on my 01 warrior, no adjustment needed in my case
Bolted right up and ran perfect! Only adjustment needed was to idle down a tad.Quad runs great now! Was gonna rebuild original and run this one temporarily but it's preforming as good as the oem. The extra jets and accessories is a plus
T**R
Not a direct fit but doable.
You can't beat the price and ultimately it worked but I ended up having to buy 2 because I damaged the first. I installed on a 2001 Yamaha Warrior 350.The throttle cable tubing is longer than factory and found I needed to modify the tubing to make it work. Be careful because I damaged the first one by breaking the casting which could not be repaired.Secondly, the throttle cable is held on the the carb with a 4mm screw. The new carb did not come tapped. Do this before you install.Thirdly, the bowl drain valve did not come with an o-ring so it leaked out once filled. Had to add one to keep it from leaking.After that, it seems to work fine so far.
G**I
Great carburetor
Good price, good replacement carb for my atv. Thanks would recommend. Mounting nuts too big, but I used the stock ones
Trustpilot
2 months ago
3 weeks ago