Yarlung 1.9cm x 76.2m Roll Birch Plywood Edge Banding, Preglued Real Wood Veneer Edging, Iron on with Hot Melt Adhesive, Flexible Wood Tape Sanded to Perfection for Furniture Restoration

Served the intended purpose

After over a year, the product has held up well for all my uses. I am ordering 2nd roll as I only have about 20' left from the last roll. I didn't have any parts that were unusable. Some of my pieces were applied to joined plywood that were 10' long. A few finger joints on short boards (2-3') would have been more noticeable because of viewing location or angles, so I chose to start after the finger joint and loose a foot of banding for a cleaner looking edge._________________________________________________I was hesitant to purchase this product after reading some of the reviews, but I have had no issues with it. I have used over 1/3 of the roll already and was able to use all of it. No flaws, missing glue or damage like some reviews claimed plagued their rolls. There are finger joints through out the roll, but that was expected. The joints are very clean, well adhered and not very noticeable on the finished product.The only issue I had, which I believe was user error were a few times the center bubble away from the edge, but this edge banding is slightly wider than the plywood. The plywood is almost 3/4 inch and if you lay the wood flat on a surface when still hot, being wider caused some bubbles. I was able to reheat and seal those areas and made sure to lay the fresh edge off the edge of my table until cooled and trimmed. Since not laying flat on the bench until cooled and trimmed, I have not seen this issue again.

This 3/4 inch birch veneer is like the magician of the woodworking world – making my projects look way more sophisticated than my carpentry skills should allow. It's so user-friendly that even my hammer is considering early retirement. The only downside is, my furniture now thinks it's too fancy for the room. I caught my coffee table practicing its French accent. Great value, easy to use, and the newfound sophistication of my DIY projects might just lead to a rebellion in my living room! Who knew wood could be so posh? Birch, you've turned my humble creations into woodworking royalty!

The roll i got was also a bit rough on the edges- ok for the cost - the glue is good and its cheap enough, you can avoid the splices for prominent areas. I got a lot of slivers trimming and sanding it but it finished ok.I used it on maple and birch veneer ply on some furniture and storage cabinets I built.

Easy application with an iron. Looking forward to completing the project with the banding.