Cargo Tie-Down V-Ring Anchors Black Steel Bolton Trailer V-Ring Tie Down for Trailers Trucks and Warehouses Replacement for D-Ring Plastic Flush Mount Pan Fitting Tiedown 4-Pack

They work like they’re supposed to

When I purchased my 2020 Nissan Frontier used it came with the utilitrack in the bed, but it didn’t have the factory hold downs. After researching prices and alternatives this is what I came up with. The factory hold downs cost $50+ each. This solution cost me less than one and I got 8 and they look neater to me. Besides the tie downs you need 3/8” cone nuts, 3/8” fender washers (1.5” diameter), and 3/8” button head screws 1” long. They can be slide along the track by loosing the screw with an Allen wrench. I am happy with my solution and they are more compact than the factory hold downs.

These are nice and the rating makes me very confident in their strength; however, I had planned on attaching my cargo net to these and found they make a bit of a cringy metal on metal sound as the cargo net moved up and down. I don't doubt I'll yet find a different use for them but couldn't use them as I'd hoped.

Combined with a M8 (8mm) bolt, made great tie down for Yamaha Viking side by side. Work great!

I installed on my RunAway Ridge Runner trailer using the bolts that hold the trailer body to the trailer frame. I changed the P3 head bolts to carriage stainless bolts and stainless nylon nuts with flat stainless washers under the nuts. I wanted the V rings to hold down the camping gear as needed. I bought the 8 pack. I've used 4 thus far. As I progress outfitting the trailer expect I may need the other set of 4.The V-rings are made in China. They seem to be of good quality. I expect they will do what I need them to do.

Installed i Toyota tundra,over the factory bed protector,just drill hole where rails go thru plastic,looks clean,sturdy,for tarp tiedown.good value,need some for front and tailgate,looking at options.

Funciona pero si es para exterior a agua y sereno se va a oxidar. De lo contrario es bueno.

Bought these to mount on the 6 bed mounting bolts in my F-150. I had to drill out the holes to make them fit the factory bolts, but after this was done, they went on very easily and stayed in place. They will rust when scratched, but look good in black on the truck bed. I put about 250 lbs of load on them while tying down an ATV and they showed no signs of weakness. I'm very happy with this purchase.